Friday, October 25, 2024
Thursday, August 22, 2024
Martin Hawaii Mars
Not Car stuff but as I am a tour Guide at the Museum We all moved the Hawaii Mars across the field to it,s resting place.
Thursday, April 25, 2024
We just returned from five weeks in South America. a week in Buenos Aires then Montevideo.
Out to the Falkland Islands and around the bottom of South America up the coast of Chile Peru and the Panama to Florida. Picked up one or two in many of the ports
Monday, February 5, 2024
Friday, November 3, 2023
Using the dual pulleys cuts down the room I only have 1/2 inch between the pulleys and the rad support and 1/4 inch between the fan and distributor cap!
The single 94 is for break in and then the Early Hexagon intake and Hexagon Air Cleaner go on
I have considered using a four bolt Merc intake and a 56 Chev two barrel we will see the dual Hexagon looks great especially with the cast iron finned heads but a full hood and who will know. I do not normally open the hood. folks can look through the louvers.
Beside I do not go to shows I just drive it.
Bills engine will be great Pre oil next week and then I will light it off.
Friday, October 13, 2023
Thursday, October 12, 2023
It has been awhile! But here is the latest. I managed to get a press pass thanks to Thomas and Carsten. This is the now world known Beach Races at ROMO on the West coast of Denmark An Island just out in the North Sea. Connected by a 5 KM causeway all sand!
Wednesday, October 4, 2023
Been a while but here is todays project.
I want some carb screens for this old adapter so here we have it.
Mama and I went to the dollar store to get some birthday. anniversary. sympathy. cards for our card stock. never know when you will need one!
Wandering around I saw some sink drain traps for small bits that might plug up a drain.
Stainless steel, with just the right dia base which when I trimmed down fit tight over a 48.81,94,97 carb throat.
They fit so tight I will not need a clamp
Ah yes making stuff out of junk is what I do best!
Wednesday, August 30, 2023
Here is a dust pan I made for Al Clark.
Al is the originator of Northwest Deuce Days in Victoria
He is moving and had a garage sale which I missed as We were at ROMO in Denmark. I dropped by and he had a few Deuce day licence plates left and a Mickey Thompson Con rod from his old 354 Hemi dragster engine, Had a spun bearing
So I made this for him
Now every time he sweeps the floor he will recall that engine.
As it was gathering dust on the bench now it can be used to pickup that dust!
Friday, May 5, 2023
Cast Iron Kogel heads and the original Hexagon Tool air filter. should be nice.
I used the dual belt system as the water pumps for a truck have bearings and not bushings
Monday, August 8, 2022
Saturday, August 6, 2022
The Prairie Schooner
We are so pleased Bill has it and will enjoy it as we have all these years.
Sunday, July 24, 2022
Thursday, May 20, 2021
I took the Hot Rod for a drive and got about two blocks and KA POW! In with the clutch and coasted around the corner. Lots of noise so I walked home with my tail between my legs! Chris the neighbour had a strap so we hauled it home behind his 1/2 ton.
Monday, September 28, 2020
Monday, September 14, 2020
TOY RUN
Annual Christmas Toy Run
Notice the smoke,that is not Sea Fog!