Canadian Hot Rod Magazine has  my trip to ROMO in it Christmas issue 23/24

 

Working on the rad install.

As is visible there is not much room

When I built the car I did not want to cut the firewall so it was measure twice and cut  once 

Using the dual pulleys cuts down the room I only have 1/2 inch between the pulleys and the rad support and 1/4 inch between the fan and distributor cap!

But I have 30 years of use on this  mind you this is my third engine.

The single 94  is for break in and then the Early Hexagon intake and Hexagon Air Cleaner go on

I have considered using a four bolt Merc intake and a 56 Chev two barrel  we will see the dual Hexagon looks great especially with the cast iron finned heads but a full hood and who will know. I do not normally open the hood. folks can look through the louvers.

Beside I do not go to shows  I just drive it.

Bills engine will be great  Pre oil next week and then I will light it off.